UBS Anti-Gravel

Surface and substrate preparation

The product shows very good adhesion to the following substrates:
— polyester laminates
— polyester putties
— epoxy primers
— two-component acryl fillers
— steel substrates,
— steel rustless surfaces
— aluminium substrate,
— plastic materials
— wash primer

Polyester laminates should be degreased, dry ground (P80-P120) and degreased again.
Polyester putty should be degreased, dry ground (P120).
Stainless material should be degreased.
Steel surface should be degreased, dry ground (P80 – P120) and degreased again.
Aluminium and galvanized surface should be degreased, dulled with the abrasive cloth and degreased again.
Old coatings should be degreased, dry ground (P220 – P280) and degreased again.
Plastic surface should be clean by water and detergent, dulled with the abrasive cloth and degreased again. We recommend warming the plastic element to temperature of 500°C, which facilitates the removal of any silicone from the surface.

Application

The best temperature for application: 15-25 °C.
Shake the bottle before use 2 min and try spray on cardboard first.
Spray the surface from a distance of about 25-30 cm. Apply 2-3 layers of the agent on time 2-5 minutes. Before another layer shake the bottle.
Clean the spray nozzle after use! – Holding the can with the valve pointing downward, press the button emptying the content for about 5 seconds.
In case of direct application on steel surface recommended imposition of the top layer of lacquer or enamel.
Caution: To maintain safety, always follow the instructions given in the Safety Data Sheet for the given product